How to Bypass Ford Pats System Without Key

Have you ever lost your car’s key? Did you ever wonder about How to Bypass Ford Pats System Without Key? If yes, you are at the right place! There is nothing tenser than losing the key of your car as you can’t get in the car without your car keys. But guess what? We have the best solutions for you!

Want to know more about How to Bypass Ford Pats System Without Key? Well, just have a look below as we have a comprehensive step-by-step guide on How to Bypass Ford Pats System Without Key. So, let’s get started;

Step-by-step Guide to Bypass Ford PATS System

Step 1: What You’ll Need

Following are the essential things you exactly need to efficiently disable the Pats system;

To enter the car, you’ll need a flathead screwdriver. The lack of a screwdriver isn’t a problem; instead, use anything straight.
Cut the replacement keys to match the originals.
To sling the transponder, you’ll need the tape once you remove the original key.

Step 2: Cut the Keys

Once the keys are made, you’ll need to take them to an auto dealer to get them programmed. As a result, the new keys will be able to match the old ones as they are sliced. As a result, you’re ready to turn the key and get the engine going. Even without the chipped key, the engine will start. This time, we’ll utilize the new keys to trick the computer into thinking you’re using the transponder key. If you want to utilize the keys going forward, make sure they are cut.

Step 3: Take the Transponder Out

Remove the chip from the transponder now that you have fresh keys. Using this chip, you can mislead the automobile into thinking you are using the original key, allowing you to get into the car. However, if you don’t have the chip, the engine won’t start.

To remove the chip, perform these steps:

A flathead screwdriver is needed.
The top of the key has a little square on the right side.
Use the screwdriver to get access to the vehicle’s interior.
Make careful you don’t slam the keys down too hard. The keys might be damaged if you push down too hard.
Screwdriver in place, remove the transponder from the key with it.

That’s fantastic. As a result of your removal of the transponder, you may now use the new keys that you purchased and cut.

Step 4: Disable PATS System

You can’t get into your automobile without a transponder, and that’s why we deactivated it in the first place. As a precaution, a transponder will be fitted in the ignition. The automobile will think you’re using the old keys when you insert new ones with a transponder.

To install the transponder, follow these steps:

Tape the transponder to the ignition in the precise position.
Make sure the chip is placed in an area where the automobile can readily read it. The automobile will not start if it is unable to do so.
To start the engine, insert the newly-cut key into the ignition.
To see whether the automobile is beginning, turn the ignition switch. The chip may need to be repositioned till it starts operating again if it doesn’t.

Failure to place the transponder correctly on the first try is not a cause for concern. To obtain the perfect position, may take a few attempts. Keep trying until you discover the correct position for the chip, even if you accidentally activate the theft lightly. This will be highly helpful for you to do the task efficiently. So, just follow the above steps and thank us later!

Hope this article will be highly helpful for you and you will get a deep understanding of How to Bypass Ford Pats System Without Key!

Good Luck, guys!

How to Bypass Ford Pats System Without Key